Reviewing Performance and Adjusting Configuration (PMP)

Review the performance of the link and adjust the antenna at the Subscriber Module, confirm that the selected equipment meets the performance objectives:

Click icon_expand_tree which is left side of the menu_pmp_nd in the left panel of the page.

This displays the PMP Links added to the project.

Click on icon_expand_tree which is left side of the Golf Club : 090 PMP Network Device. This lists all the Subscriber Module attached to the Network Device.

Click on Billing Street. This displays all the properties of the Subscriber Module.

The right hand side of the window shows the Profile, Performance Summary and Performance Details section in this page.

  1. View the performance of the link between the Network Device and the Subscriber Module.

  2. Insert the required performance objective of x6 (64QAM MIMO-B) at both ends of the link, using the Min Mod Mode Required field.

  3. Set the Min Availability Required to 99.9% at both ends of the link

note

The results shown are using the ITU-R P.530-17 propagation model

Observe that the Max Usable Mode values and Predicted Availability are now red because they are less than the required values.

_images/Performance_Unacceptable_at_Both_Ends_of_PMP_Link.png

Performance Unacceptable at Both Ends of PMP Link

Adjust the configuration to make the performance at both ends acceptable.

  1. Change the Antenna Height of Billings Street SM to 23 meters.

    Click save

note

If any properties of the SM are changed, save the configuration to update the calculated results.

_images/Adjust_Both_Ends_of_PMP_Link.png

Adjust Both Ends of PMP Link

  1. Confirm that the predicted values meet performance objectives.

    _images/Performance_Acceptable_at_Both_Ends_of_PMP_Link.png

    Performance Acceptable at Both Ends of PMP Link

  1. Confirm the detailed performance parameters at each mode.

    _images/Detailed_Performance_at_Both_Ends_of_PMP_Link.png

    Detailed Performance at Both Ends of PMP Link

  2. Click Projects in the top menu bar and then click Save save_project