Advanced Features

To improve the performance of links additional features are available in certain PTP products.

For PTP 670 or 700

• Optimize E1 or T1 latency, see Optimizing E1 or T1 Latency

• Use Diversity, see Setting Diversity

For PTP 670 or 700

• Use TDD Synchronization, see Setting TDD Synchronization. For further background information giving an overview of Time Division Duplex, see TDD Overview or for an overview of TDD Synchronization, see TDD Synchronization Overview.

For PTP 820 or 850

• Enable Hot Standby Protection, including Spatial Diversity, see Setting Hot Standby Protection (1+1)

• Use 2+0 Single Antenna, see Setting 2+0 Single Antenna

For PTP 670, 700, 820C, 820A and 820G products

• Use Diversity, including Reflections, see Setting Diversity

• Optimizing E1 or T1 Latency
• Setting TDD Synchronization
• TDD Overview
  • TDM Mode
  • IP Mode
  • Symmetry
  • Summary
• TDD Synchronization Overview
  • Unsynchronized Links
  • Synchronized Links
• Setting Diversity
  • Space Diversity
    • Reflections over Water
    • Multipath Reflections
  • Configuring Spatial Diversity in LINKPlanner
    • PTP 670
  • Height Clearance
• Setting 2+0 Single Antenna
  • 2+0 Equipment Configuration
  • 2+0 Configuration at Each End
  • 2+0 Bill of Materials
  • 2+0 Performance Summary
  • 2+0 Reports
• Setting Hot Standby Protection (1+1)
  • Hot Standby Configuration at Each End
  • Hot Standby Bill of Materials
  • Hot Standby Performance Summary
  • Hot Standby Reports
    • Proposal Report
    • Installation Report